SWITCH 8P LAN GIGABIT HIKVISION DS-3E1510P-EI 8P RJ45 POE -2P GIGABIT RJ45 - L2 SMART MANAGED

General
Shell material: Metal
Power Supply: 54VDC, 2.22A
Power Consumption In Idle: 2.7 W
Max. Power Consumption: 120 W
Surge Protection: 6 KV
Installation Mode: Desk-Mounted, Wall-Mounted
Dimensioni: 217.6 × 27.6 × 108.5 mm
Gross Weight: 1.27 kg
Net Weight: 0.54 kg
Operating Temperature: 0 °C to 40 °C
Storage Temperature: -40 °C to 85 °C
Operating Humidity: 5% to 95% (no condensation)
Relative Humidity: 5% to 95% (no condensation)

Network Parameters
Porte: 
- 8× porte Gigabit PoE port
- 2× porte Gigabit RJ-45 port
MAC Address Table: 4 K
Switching Capacity: 20 Gbps
Packet Forwarding Rate: 14.88 Mbps
Internal Cache: 1.5 MB

PoE Power Supply
PoE Standard: IEEE 802.3af, IEEE 802.3at
PoE Power Pin End-span: 1/2(-), 3/6(+)
PoE Port: PoE: Ports 1 to 8
Max. Port Power: 30 W
PoE Power Budget: 110 W

Software Function
Long Range (Ports 1 to 8): up to 300 m (performance may vary depending on camera model or cable condition)
Port Isolation (Ports 1 to 8): port isolation mode to improve network security (Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group)
PoE Watchdog (Ports 1 to 8): auto detect and restart the cameras that do not respond
Link Aggregation: Support static link aggregation, Support 3 aggregation groups
Link aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection.
Loop Prevention: Support 802.1D STP, Suppport 802.1w RSTP
Loop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.
VLAN: 
- Support 802.1Q
- Configurable VLAN ID from 1-4094
- Support Trunk, Access port mode
- Support Max. 32 VLAN
- VLAN is used for network scale planning and network health improvement.
HPP: Support one-click activation and remote management via Hik-Partner Pro
HPP Functions supported: 
- Display the port rate.
- Display the port bandwidth utilization rate.
- Display the PoE power usage.
- Display topology information.
- Display the alarm status.
- Restart ports and devices.
- Enable port long-rage mode.
- Remotely upgrade the device.
System Maintenance: 
- Support device management via web.
- Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.
- Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.
- Support management via Hik-Central Pro.
- Support remote management via Hik-Partner Pro.
- Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.
- Supports 802.1ab LLDP for peer device discovery.
- Support port mirroring for fault locating.

Approval
EMC: CE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
Safety: CB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)
Chemistry: CE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)